Filter
Top Products
3
51GFK-0827 Chapter 3 Configuration
When you have completed configuring Genius blocks, press the Esc key to go from the
block level display back to the bus level display. The bus display will now appear as
shown below.
Configure the Bus Transmitter Module
Press the Esc key to return to the rack level display. A message will be displayed
reminding you to configure a Bus Transmitter Module for this rack (since it had not been
configured earlier). Press Esc again. Move the cursor to slot 4, press the bem softkey
(F1), then press the btm softkey (F1) to select the Bus Transmitter Module, and press
Enter. The detail screen for the Bus Transmitter Module will appear.
Press the Esc key which will return you to the rack level display. At this point you have
completed the necessary configuration steps for the Primary PLC and can proceed to
configuring the Secondary PLC.