Filter
Top Products
3
31GFK-0827 Chapter 3 Configuration
cable connecting the PLC to the programmer should only be plugged and unplugged
when the programmer is powered up and offline. Avoid powering the parallel programmer
up or down while connected to a running PLC.
Configuration of a Redundancy CPU Module
The redundancy CPU module, IC697CPU 780 must be configured as a rack module in
rack 0, slot 1. The procedure for configuring a CPU 780 in a rack is described below.
While in the Logicmaster 90 main menu, select the Logicmaster 90 Configuration
Package by pressing the F2 softkey. You will then be prompted to enter a folder name or
select an existing folder. When you have done this, press the Enter key and the Series
90-70 Configuration software main menu will appear.
While in the Configuration Software main menu, select the I/O softkey (F1) for I/O
Configuration. The default I/O Configuration Rack screen is displayed.
To configure the CPU 780 module position the cursor on rack 0, slot 1, then press the
zoom softkey (F10).