Renesas SH7264 Doll User Manual


  Open as PDF
of 2152
 
Section 21 IEBus
TM
Controller
R01UH0134EJ0400 Rev. 4.00 Page 1083 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Section 21 IEBus
TM
Controller
This LSI has an on-chip one-channel IEBus controller. The Inter Equipment Bus
TM
(IEBus
TM
)* is a
small-scale digital data transfer system for inter-equipment data transfer.
This LSI does not have an on-chip IEBus driver/receiver, so it is necessary to mount a dedicated
driver/receiver externally. In addition, as the IERxD and IETxD pins need 3V to operate, a
dedicated external level shifter is necessary.
Note: * The Inter Equipment Bus
TM
(IEBus
TM
) is a trademark of Renesas Electronics
Corporation.
21.1 Features
IEBus protocol control (layer 2) supported
Half-duplex asynchronous communications
Multi-master system
Broadcast communications function
Selectable mode (three types) with different transfer speeds
On-chip buffers for data transmission and reception
Transmission and reception buffers: 128 bytes each
Up to 128 bytes of consecutive transmit/reception (maximum number of transfer bytes in
mode 2)
Operating frequency
12 MHz, 12.58 MHz (This module uses 1/2 divided clocks of P, or AUDIO_X1*,
AUDIO_X2*.)
18 MHz, 18.87 MHz (This module uses 1/3 divided clocks of P, or AUDIO_X1*,
AUDIO_X2*.)
24 MHz (This module uses 1/4 divided clocks of P, or AUDIO_X1*, AUDIO_X2*.)
25.16 MHz (This module uses 1/4 divided clocks of P.)
30 MHz, 31.45 MHz (This module uses 1/5 divided clocks of P.)
36 MHz (This module uses 1/6 divided clocks of P.)
Note: * Available as this module clock input only when not used as the clock input for serial
sound interface, serial I/O with FIFO, or Renesas SPDIF interface.
Module standby mode can be set.