Renesas SH7264 Doll User Manual


  Open as PDF
of 2152
 
Section 20 Controller Area Network
Page 1020 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit 9: IRR9 Description
0 No pending notification of message overrun/overwrite
[Clearing condition]
Clearing of all bit in UMSR/setting MBIMR for all UMSR set (initial value)
1 A receive message has been discarded due to overrun condition or a
message has been overwritten
[Setting condition]
Message is received while the corresponding RXPR and/or RFPR = 1 and
MBIMR = 0
Bit 8 - Mailbox Empty Interrupt Flag (IRR8): This bit is set when one of the messages set for
transmission has been successfully sent (corresponding TXACK flag is set) or has been
successfully aborted (corresponding ABACK flag is set). In Event Triggered mode the related
TXPR is also cleared and this mailbox is now ready to accept a new message data for the next
transmission. In Time Trigger mode TXPR for the Mailboxes from 30 to 24 is not cleared after a
successful transmission in order to keep transmitting at each programmed basic cycle. In effect,
this bit is set by an OR'ed signal of the TXACK and ABACK bits not masked by the
corresponding MBIMR flag. Therefore, this bit is automatically cleared when all the TXACK and
ABACK bits are cleared. It is also cleared by writing a '1' to all the correspondent bit position in
MBIMR. Writing to this bit position has no effect.
Bit 8: IRR8 Description
0 Messages set for transmission or transmission cancellation request NOT
progressed. (Initial value)
[Clearing Condition]
All the TXACK and ABACK bits are cleared/setting MBIMR for all TXACK
and ABACK set
1 Message has been transmitted or aborted, and new message can b e stored
(in TT mode Mailbox 24 to 30 can be programmed with a new message only
in case of abortion)
[Setting condition]
When a TXACK or ABACK bit is set (if related MBIMR = 0).