Filter
Top Products
AdministrativeTasks
2-18 Operating Tasks 600716 Rev A
In the figure below, the fsrollup command fails to roll up to
dir1 from dir2 because dir6 is not a migration directory.
The
fsrollup function is performed on only one hierarchical
directory level at a time. Roll up of a DataClass group to a
directory that is two or more levels above an upper boundary
directory of the DataClass group is not allowed. The user
cannot roll up past a file system mount point. The specified
directory contains only subordinate directories and no other
files.
Perform this adjustment before many files are stored to the
directories.
Step 1. Verify that the rollup does not cause contention with
other migration directories
Step 2. Run the fsrollup command.
/dir1
dir2
dir4dir3 dir5
DataClass A
Before Rollup
dir6
dir7
/dir1
dir2
dir4dir3
dir5
DataClass A
After the command
dir6
fsrollup /dir1/dir2
dir7
DataClass A