Filter
Top Products
AdministrativeTasks
600716 Rev A Operating Tasks 2-57
Operaitng Tasks
Remove Media Step 1. Run the fsmedout command with the media
identifiers and the -r option for the media to be
checked out. The -t labeltext option is not supported
at this time.
Step 2. The physical location of the media (-l location) is
used for tracking the media and is limited to 255
characters.
Media are logically checked out of the FileServ
system.
Step 3. Contact the VolServ operator to complete the
operation and to obtain the media.
Add Blank Media FileServ uses the
fsmedin -b command to logically enter
blank media into FileServ software.
Blank media can be added to the general blank pool or to a
specific DataClass group pool. Blank media in the general
blank pool are available for use in any DataClass group. Blank
media in the DataClass group pool are only available for use by
that particular DataClass group.
The quantity of media being added can be optionally entered as
an argument of the
fsmedin -b command. The quantity
option is primarily used when a specific number, less than the
value specified by the system VS_DEF_QUANTITY parameter,
is needed.
Note
For more information on the fsmedin command, refer to the
Command Reference book.