Filter
Top Products
Administrative Tasks
1-36 System Tasks 600716 Rev A
Default Parameters The FileServ default parameters are used with FileServ
commands that allow defaults (
fsaddclass and
fsmodclass). To change a default, modify this file, cycle
FileServ, then retry the command.
Review these parameters to verify that the applicable defaults
are site specific. Because the defaults are used when no specific
value is indicated in a command, these defaults are set to values
that are most often used. This allows increased use of the
defaults in the commands. Modify those values that are contrary
to a site’s specific operations. The following example illustrates
the type of issues for which it is beneficial to modify the
FileServ defaults.
CLEANUP_PROCESSING 100 Number of files processed per
transaction in the fsclean
command. If this value is set higher
than 100, the results can be
memory allocation problems and
increased processing time. 100 is
the recommended value.
FS_PRINTER_PATH /usr/bin/lpr Default printer used for printing
reports from the GUI.
MDM_POSITION_VALIDATION YES Enables validation of the tape
position prior to the first file in a file
set.
Parameter Default Definition