PathBuilder S24x, 26x, and 27x Switch Hardware Installation 3-23
Installing the Transceiver
Installing the Transceiver
Introduction The transceiver mounts to the DB-15 AUI connector of the Ethernet LAN card or to
the DB-15 AUI connector on the back panel. The Thin-Net BNC connector provides
subsequent interface to the coaxial network.
The SQE can be turned ON and OFF by setting a switch on the side of the housing.
Note
The transceiver is shipped with the SQE set to the OFF position.
Transceiver
Illustration
Figure 3-7 shows a transceiver.
Figure 3-7. Transceiver
Thin-NET BNC Connector
15-Pin D-Type Connector
SQE Switch