Filter
Top Products
Preparation and Unpacking 2-5
The PathBuilder S24x, 26x, and 27x Switch Rackmount Kit
The PathBuilder S24x, 26x, and 27x Switch Rackmount Kit
Introduction You can install the PathBuilder S24x, 26x, and 27x switch in a standard Electronics
Industry Association (EIA) 19-inch equipment rack.
EIA Rackmount Kit The PathBuilder S24x, 26x, and 27x switch EIA Rackmount kit contains the
following components:
• One Mounting Shelf
• Two adjustable Rear Mounting brackets for rear rail attachment
• Four Phillips-head 10-32 x .38 long screws with integral lock washers
• Eight Phillips-head 12-24 x.50 long screws for front and rear rail attachment
• Three longer #6 screws
When Checking the
EIA Rackmount Kit
Be aware of the following issues when checking the components of your rackmount
kit:
• The Mounting Shelf and adjustable Rear Mounting brackets ship fastened
together at the Mounting bracket’s front-most adjustment hole. This prevents
damage during shipping. Disassemble these components prior to installation.
• The four Phillips-head 10-32 x .38 long screws ship in holes securing the
Mounting Shelf to the Rear Mounting brackets. Remove them to separate the
shelf and brackets.
• The eight Phillips-head 12-24 x .50 long screws ship in a small plastic bag.