1-44 About the PathBuilder S24x, 26x, and 27x switch
Telecommunications Regulations
In Canada, the following equipment attachment limitations and information must be
provided in the user instructions:
Caution
Users should not attempt to make such connection themselves, but should contact the
appropriate electric inspection authority, or electrician, as appropriate.
Mise en Garde
Les utilisateurs ne doivent pas établir de telles connexions eux-mêmes. Ils doivent
contacter une personne compétente ou un électricien.
Warnung
Benutzer sollten nicht versuchen, diese Verbindung selbst herzustellen, sondern
dazu die zuständige Aufsichtsbehörde für Elektroinstallationen bzw. einen
Elektroinstallateur kontaktieren.
Note
The Load Number (LN) assigned to each terminal device denotes the total load
percentage to be connected to a telephone loop used by the device to prevent
overloading. The loop termination can consist of any combination of devices as
long as their total LNs do not exceed 100.
The Canadian Department of Communications label identifies certified equipment.
This certification means that the equipment meets certain telecommunications
network protective operational and safety requirements. The Department does not
guarantee the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is permissible to be
connected to the facilities of the local telecommunications company.
The equipment must also be installed using an acceptable method of connection. In
some cases, the company’s inside wiring associated with a single line individual
service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations made by
the user to this equipment, or equipment malfunctions, may give the
telecommunications company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that the electrical ground connections
of the power utility, telephone lines, and internal metallic water pipe system, if
present, are connected together. This precaution may be particularly important in
rural areas.