Filter
Top Products
3-16 PathBuilder S24x, 26x, and 27x Switch Hardware Installation
Installing I/O Cards
Installing I/O Cards
Introduction These PathBuilder S24x, 26x, and 27x switch I/O cards are installed into slots 1
through 8:
• Serial Data Board (SDB)
• BRI
•Hub
The Modem card can only be installed into slot 1.
Installing an I/O
Card
Perform these steps to install any of the I/O cards:
Step Action
1 Align the card and the appropriate slot.
2 Insert the card, making the proper connection on the motherboard.
3 Fasten each card with a single holding screw to the rear of the
PathBuilder S24x, 26x, and 27x switch chassis.