Renesas R5S72646 Doll User Manual


  Open as PDF
of 2152
 
Section 26 USB 2.0 Host/Function Module
Page 1382 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
26.3.11 Interrupt Enable Register 1 (INTENB1)
INTENB1 is a register that enables or disables the various interrupts when the host controller
function is selected. On detecting the interrupt corresponding to the bit in this register that has
been set to 1, this module generates the USB interrupt.
This module sets 1 to each status bit in INTSTS1 when a detection condition of the corresponding
interrupt source has been satisfied regardless of the set value in INTENB1 (regardless of whether
the interrupt output is enabled or disabled).
While the status bit in INTSTS1 corresponding to the interrupt source indicates 1, this module
generates the USB interrupt when the corresponding interrupt enable bit in INTENB1 is modified
from 0 to 1.
When the function controller function is selected, the interrupts should not be enabled. This
register is initialized by a power-on reset.
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Bit:
Initial value:
R/W:
0000000000000000
R R/W R R/W R/W R R R R R/W R/W R/W R R R R
BCHGE DTCHE
AT T
CHE
———
EOF
ERRE
SIGNE SACKE
Bit Bit Name
Initial
Value
R/W Description
15 0 R Reserved
This bit is always read as 0. The write value should
always be 0.
14 BCHGE 0 R/W USB Bus Change Interrupt Enable
Enables or disables the USB interrupt request when
the BCHG interrupt is detected.
0: Interrupt request disabled
1: Interrupt request enabled
13 0 R Reserved
This bit is always read as 0. The write value should
always be 0.
12 DTCHE 0 R/W Disconnection Detection Interrupt Enable
Enables or disables the USB interrupt request when
the DTCH interrupt is detected.
0: Interrupt request disabled
1: Interrupt request enabled