Renesas R5S72646 Doll User Manual


  Open as PDF
of 2152
 
Section 22 Renesas SPDIF Interface
Page 1162 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
13 UBO 0 R/WC0 User Buffer Overrun*
Sets if the receiver user buffer overruns. This bit is
cleared by writing 0 to the register. If bit REIE and bit
UBOI in the control register are set this causes an
interrupt.
0: User buffer has not overrun
1: User buffer has overrun
12 UBU 0 R/WC0 User Buffer Underrun*
Sets if the transmitter user buffer underrun. This bit is
cleared by writing 0. If bits TEIE and UBUI in the control
register are set this causes an interrupt.
0: User buffer has not underrun
1: User buffer has underrun
11 CE 0 R/WC0 Clock Error*
Sets when the clock recovery falls out of synchronization.
This bit is cleared by writing 0. If bits REIE and CREI in
the control register are set this causes an interrupt.
0: Clock recovery stable
1: Clock recovery error
10 PARE 0 R/WC0 Parity Error*
Sets when the parity checker produces a fail result. This
bit is cleared by writing 0. If bits REIE and PAEI in the
control register are set this causes an interrupt.
0: Parity check correct
1: Parity error
9 PREE 0 R/WC0 Preamble Error*
Sets when the start of word preamble fails to appear in
the correct place. This bit is cleared by writing 0. If bits
REIE and PREI in the control register are set this causes
an interrupt.
Note: Only set after a start of block preamble has
occurred.
0: Preamble is in the correct place
1: Preamble error