Filter
Top Products
16. Servicing
Image 16-6
CAUTION: Ensure that all unused input slots of the input & communication unit are always covered with a
dummy front plate. After removing one of the input modules, immediately replace with an other one or install
a dummy front cover on the unused input slot.
16.4 Installation of the lamp house
WARNING: This procedure may only be performed by qualified technical service personnel.
CAUTION: Never attempt to disassemble the lamp from its housing or to dispose of it. Return it to Barco.
Due to its high internal pressure, the lamp may explode in either hot or cold states if improperly handled.
Necessary tools
7mmflat screw driver.
How to install the lamp house of the projector ?
1. Ensure the projector is switched off and the power cord at the projector side is unplugged.
2. Remove the lamp cover, if not removed yet. See "Removal of the lamp cover", page 193.
3. Clasp the lamp house by its handles and gently slide the lamp house into its socket. Note that the compartment is provided with
guides (G) to position the lamp house correctly.
G
C
Image 16-7
186 R5976986 FLM HD18 15/03/2010