Renesas R5S72641 Doll User Manual


  Open as PDF
of 2152
 
Section 27 Video Display Controller 3
Page 1584 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
27.7.8 Video Storing Field Count Register (VIDEO_SAVE_NUM)
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16
151413121110987654321
0
0000000000000000
RRRRRRRRRRRRRRRR
0000000000000000
RRRRRRR/WR/WR/WR/WR/WR/WR/WR/WR/WR/W
------
-
FIELD_NUM[9:0]
FIELD_SAVE_NUM[9:0]
-----
Bit:
Initial value:
R/W:
Bit:
Initial value:
R/W:
Bit Bit Name
Initial
Value R/W Description
31 to 26 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.
25 to 16 FIELD_NUM
[9:0]
H'000 R These bits indicate the field number of which
recording processing has been completed in the
video recording mode. These bits are cleared to
H'000 when the VIDEO_MAIN_EXE bit in the
VIDEO_MODE register is cleared to 0.
15 to 10 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.
9 to 0 FIELD_SAVE_
NUM [9:0]
H'000 R/W These bits specify the number of fields to be
stored. Set these bits to H'000 in the video display
mode (when the VIDEO_MODE bit in the
VIDEO_MODE register is set to 1).
H'000: One field is stored.
H'001: Two fields are stored.
H'03B: 60 fields are stored.
H'3FF: 1024 fields are stored.
Note: After data has been written for the specified number of fields, the memory is overwritten by
new video data from the first address.
Video data is stored at a 1/2-field rate (NTSC: 30 fps; PAL: 25 fps).
When the VIDEO_MAIN_EXE bit in the VIDEO_MODE register is cleared to 0, the address
calculation result is initialized and data is written to the initial field storing area.