Mitsubishi Electronics A1SD75P1-S3/P2-S3/P3/S3 Model Vehicle User Manual


 
6 - 8 6 - 8
MELSOFT
6. PROJECT CREATION
6.5.2 Reading the CSV format file
PURPOSE
GX Configurator-AP allows CSV format files created with spreadsheet software or
the like to be read as positioning data (axis #1 to #3). (Parameters and start block
data cannot be read.)
The creating method and reading operation of CSV format data are described
below.
If all items that make up positioning data have not been entered, CSV format data
cannot be read, resulting in an error.
Since CSV format data is read axis-by-axis, create CSV format data noting which
axis (#1/#2/#3) data is being created.
(1) CSV format data creating method
The following sheet indicates the items and values of CSV format data set on a
column basis. It should be noted that you cannot set the interpolation axis and
circular addresses for interpolation control.
<Example of data set to spreadsheet software>
1) 2) 3) 4) 5) 6) 7) 8) 9) 10)
<Data set to the above spreadsheet software was read with
GX Configurator-AP >
Num
ber
Setting Remarks
1) Line 1 from table top is positioning No. 1 data and line 2 is positioning No. 2 data.
2) Set the positioning control pattern in column 1 from left. Set any value of 0 to 2.
3) Set the control method in column 2 from left. Set it with 1 to 9 and A to I.
4) Set the accel time in column 3 from left. Set it with 0 to 3.
5) Set the decel time in column 4 from left. Set it with 0 to 3.
6) Set the address in column 5 from left.
7) Set the circular address in column 6 from left.
8) Set the command speed in column 7 from left.
9) Set the dwell time in column 8 from left.
10) Set the M code in column 9 from left.
Refer to Section
9.1 for details of
data
corresponding to
values and
alphabets to be
set.