Filter
Top Products
About this manual
This manual applies to the module Modbus TCP for the product
LXM32M, module identification ETH.
The information provided in this manual supplements the product
manual.
Source manuals The latest versions of the manuals can be downloaded from the Inter-
net at:
http://www.schneider-electric.com
Source CAD data For easier engineering, CAD data (EPLAN macros or drawings) are
available for download from the Internet at:
http://www.schneider-electric.com
Corrections and suggestions We always try to further optimize our manuals. We welcome your sug-
gestions and corrections.
Please get in touch with us by e-mail:
techcomm@schneider-electric.com.
Work steps If work steps must be performed consecutively, this sequence of steps
is represented as follows:
■
Special prerequisites for the following work steps
▶
Step 1
◁
Specific response to this work step
▶
Step 2
If a response to a work step is indicated, this allows you to verify that
the work step has been performed correctly.
Unless otherwise stated, the individual steps must be performed in the
specified sequence.
Making work easier Information on making work easier is highlighted by this symbol:
Sections highlighted this way provide supplementary information on
making work easier.
Parameters In text sections, parameters are shown with the parameter name, for
example _IO_act. A list of the parameters can be found in the prod-
uct manual in the chapter Parameters.
SI units SI units are the original values. Converted units are shown in brackets
behind the original value; they may be rounded.
Example:
Minimum conductor cross section: 1.5 mm
2
(AWG 14)
Inverted signals Inverted signals are represented by an overline, for example STO_A or
STO_B.
Glossary Explanations of special technical terms and abbreviations.
LXM32M
About this manual
Modbus-TCP module 7
0198441113843, V1.01, 01.2012