Renesas R5S72626 Doll User Manual


  Open as PDF
of 2152
 
Section 36 List of Registers
R01UH0134EJ0400 Rev. 4.00 Page 1959 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
Module
Name
Register
Abbreviation
Power-On
Reset
Manual
Reset
Deep
Standby
Software
Standby
Module
Standby Sleep
CD-ROM
decoder
All registers Initialized Retained Initialized Retained Retained Retained
A/D
converter
All registers Initialized Retained Initialized Initialized Initialized Retained
NAND flash
memory
controller
All registers Initialized Retained Initialized Retained Retained Retained
USB 2.0
host/func-
tion module
All registers Initialized Retained Initialized Retained Retained Retained
Video
display
controller 3
All registers Initialized Retained Initialized Retained Retained Retained
Sampling
rate
converter
All registers Initialized Retained Initialized Retained Retained Retained
General
purpose I/O
ports
All registers Initialized Retained Initialized Retained Retained
Power-down
modes
DSFR Initialized Retained Retained Retained Retained
XTALCTR Initialized*
10
Retained Retained*
9
Retained*
9
Retained
Other than above Initialized Retained Initialized Retained Retained
User
debugging
interface*
8
SDIR Retained Retained Initialized Retained Retained Retained
Motor
control
PWM timer
All registers Initialized Retained Initialized Retained Retained Retained
Notes: 1. Retains the previous value after an internal power-on reset by means of the watchdog
timer.
2. The BN3 to BN0 bits are initialized.
3. Flag handling continues.
4. Counting up continues.
5. Bits RTCEN and START are retained.
6. Bits BC2 to BC0 are initialized.
7. Transfer operations can be continued.
8. Initialized by TRST assertion or in the Test-Logic-Reset state of the TAP controller.
9. Initialized when realtime clock is not using EXTAL.