Filter
Top Products
9
About this guide
This guide describes installing and configuring a Patton Electronics Model 3086FR Frame Relay to ATM
Converter. The instructions in this guide are based on the following assumptions:
• The Frame Relay to ATM Converter may connect to a serial DTE device
• There is a LAN connected to the Ethernet port of the IAD
• Users will be connected to remote IADs
Audience
This guide is intended for the following users:
• Operators
• Installers
• Maintenance technicians
Structure
This guide contains the following chapters and appendices:
• Chapter 1 provides information about Frame Relay to ATM Converter features and capabilities
• Chapter 2 contains an overview describing Frame Relay to ATM Converter operation
• Chapter 3 provides quick start installation procedures
• Chapter 4 describes connecting the DSL and data ports
• Chapter 6 describes configure Frame Relay and ATM features
• Chapter 7 describes the Local Management Interface
• Chapter 8 describes setting up 3086FR routed and bridged ATM connections
• Chapter 9 describes configuring the Frame Relay to ATM Converter for specialized applications
• Chapter 10 describes configuring security for the IAD
• Chapter 11 describes configuring for network address translation (NAT)
• Chapter 12 contains definitions for the LED status indicators
• Chapter 13 describes Frame Relay to ATM Converter diagnostics
• Appendix B contains specifications for the IADs
• Appendix C provides cable recommendations
• Appendix D describes the IAD’s physical ports
• Appendix E describes how to use the command line interface (CLI)
For best results, read the contents of this guide before you install the IAD.