Filter
Top Products
Administering user accounts 169
Model 3086FR ATM IAD User Guide E • Command Line Interface (CLI) Operation
Enter the new password twice as prompted:
Enter new password: ***
Again to verify: ***
fi
Note
No check is made for any current password which may have been set for the
user.
If you wish to change the password for another user, enter the command:
user change <username>
This command logs you into the system as another user. You can then use the user password command to
change the password for this user.
Note
Changing to another user means that you lose all superuser privileges.
Note
Only superusers can use the user change command.
Changing user settings
To change any of the default settings for a user, use the following commands. For example, to change the set-
tings for user fred:
system set user fred access {default|engineer|superuser}
system set user fred maydialin {enabled|disabled}
system set user fred mayconfigure {enabled|disabled}
For example, to change the security level for fred, enter:
system set user fred access engineer
Note
Only superusers can use the user change command.
Controlling login access
To set user login access for user username, use the command (all on one line):
system set login < username > access {default|engineer|superuser}
Controlling user access
To set user access for user username, use the command (all on one line):
system set user < username > access {default|engineer|superuser}
G.SHDSL Commands:
Command format: ‘gshdsl Action Attribute Value’
• Action – Two types of actions are available: ‘set’ or ‘show’
• Set – set attributes with a value.
• Show – get information from the box
• Attribute – The name of the attributes to access.
• Value – The new value for the attribute (Set command only)