Patton electronic 3086FR Doll User Manual


 
E1 Interface 44
Model 3086FR ATM IAD User Guide 4 • Connecting the DSL and data ports
Web Interface Configuration
Launch Internet Explorer or similar web browser, type the IP address of the 2603, enter username ‘superuser’
and password ‘superuser’. From the main page click on the E1/T1 option > Configuration. This page allows
configuration of E1 parameters as follows:
Time Slot Select. For unframed E1 service (Clear Channel) enter time slots 0-31. For a full framed E1 enter 1-
31, for partially filled E1 enter the range of timeslots using the format for example: 1,2,3,5; or 1-5,10-31. Any
entry for timeslots above 31 will return and invalid selection message.
Line Options: Choose from Clear Channel E1, Fractional E1, Fractional E1, Multi-Frame(CAS) E1, Multi-
Frame(CAS) E1 with CRC. Consult with your service provider which option is required.
Line Code: Choose from AMI or HDB3. Most E1 applications use HDB3
Line Build Out: Select 120 ohm if the E1 connection is made via the RJ-48C connector, select 75 Ohm if the
E1 connection is made via the Dual BNC connectors.
FDL Mode: FDL is a T1 application, therefore select ‘Fdl- none’ for E1 applications.
Idle code: Options are Enabled or Disabled. When idle code is Enabled, the 3086FR/K inserts idle codes on
E1unused timeslots. Set this option to ‘Disabled’ unless instructed otherwise.
Power Down: Options are Normal and Powerdown. When the 3086FR is set to powered down, it will set the
E1 interface pins to high impedance to protect the device – set unit to “Normal” for regular operation.
Once all options have been selected, click on the
Configure and Activate
button at the bottom of the screen.
Additionally, save the configuration by going to the Configuration > Save Config menu.