Filter
Top Products
Section 9 Bus State Controller
Page 282 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
Bit Bit Name
Initial
Value R/W Description
10 RMODE 0 R/W Refresh Control
Specifies whether to perform auto-refresh or self-
refresh when the RFSH bit is 1. When the RFSH bit is
1 and this bit is 1, self-refresh starts immediately.
When the RFSH bit is 1 and this bit is 0, auto-refresh
starts according to the contents that are set in
registers RTCSR, RTCNT, and RTCOR.
0: Auto-refresh is performed
1: Self-refresh is performed
9 PDOWN 0 R/W Power-Down Mode
Specifies whether the SDRAM will enter the power-
down mode after the access to the SDRAM. With this
bit being set to 1, after the SDRAM is accessed, the
CKE signal is driven low and the SDRAM enters the
power-down mode.
0: The SDRAM does not enter the power-down mode
after being accessed.
1: The SDRAM enters the power-down mode after
being accessed.
8 BACTV 0 R/W Bank Active Mode
Specifies to access whether in auto-precharge mode
(using READA and WRITA commands) or in bank
active mode (using READ and WRIT commands).
0: Auto-precharge mode (using READA and WRITA
commands)
1: Bank active mode (using READ and WRIT
commands)
Note: Bank active mode can be set only for area 3.
When both areas 2 and 3 are set to SDRAM,
specify the auto-precharge mode.
7 to 5 All 0 R Reserved
These bits are always read as 0. The write value
should always be 0.