Honeywell 8650 Building Set User Manual


 
4 - 39
Transmit Code 39 Check Digit
When enabled, the check digit is transmitted with the data.
Parameter setting for “Code 39 Check Digit Verification” has no effect on this parameter value.
Set this parameter by scanning either of the bar codes shown below.
Trioptic Code 39
Trioptic Code 39 symbols always contain six characters.
When Trioptic Code 39 is enabled, set the “Code 39 Full ASCII” parameter to disabled. Both parameters should not be
enabled simultaneously.
Set this parameter by scanning either of the bar codes shown below.
Enable Transmit Code 39 Check Digit
* Disable Transmit
Enable Trioptic Code 39
* Disable Trioptic Code 39