Filter
Top Products
5 - 2
Ring Imager Setting 4400 Default
Set All Defaults/Cancel Bar Codes (page 5-5) All Defaults
Enable / Disable Parameter Scanning (page 5-6) Enable
Imager Parameters - General
Decode Session Timeout (page 5-6) 9.9 sec
Decode Aiming Pattern (page 5-7) Enable
Decoding Autoexposure (page 5-7) Enable
Decoding Illumination (page 5-8) Enable
Focus Mode (page 5-9) Far Focus
LED Illumination (page 5-10) (LED Illumination PL4407) Internal LED Illumination
LED Illumination (page 5-10) (LED Illumination MS4407) External LED Illumination
Operational Mode (page 5-11) Decode Mode
Power Mode (page 5-12) (Power Mode PL4407) Low Power
Power Mode (page 5-12) (Power Mode MS4407) Continuous On
Presentation Mode Session Timeout (page 5-12) 2 sec
Time Delay to Low Power Mode (page 5-13) 1 sec
Time-out between Decodes, Same Symbol (page 5-14) 0.6 sec
Trigger Modes (page 5-15) Trigger Mode PL4407) Level
Trigger Modes (page 5-15) (Trigger Mode MS4407) Presentation Mode
Report Version (page 5-16) Current Software Version
Transmit Code ID Character (page 5-16) None
Prefix / Suffix Values (page 5-22) Prefix: Null, Suffix 1 : LF, Suffix 2: CR
Scan Data Transmission Format (page 5-23) Data As Is
Transmit “No Read” Message (page 5-25) Disable
Simple Serial Interface (SSI) Options Not Supported
Event Reporting Not Supported
Serial Host Parameters Not Supported
Beep After Good Decode Not Supported
Beeper Tone Not Supported
Beeper Volume Not Supported
FN1 Substitution Values Not Supported
Prefix / Suffix Values Not Supported
Symbologies
UPC/EAN
UPC-A (page 5-26) Enable
UPC-E (page 5-26) Enable
UPC-E1 (page 5-27) Disable
EAN-8/JAN-8 (page 5-27) Enable
EAN-13/JAN-13 (page 5-28) Enable
Bookland EAN (page 5-28) Disable
Bookland Format (page 5-29) Bookland 10
Decode UPC/EAN/JAN Supplementals (2 and 5 digits) (page 5-29) Ignore Supplementals
UPC/EAN/JAN Supplemental Redundancy (page 5-31) 10
Transmit UPC-A Check Digit (page 5-31) Enable