Filter
Top Products
5 - 5
Set All Defaults/Cancel Bar Codes
Use the Set All Defaults bar code to return all parameters to their default values. Scanning this bar code does not affect the
mobile device’s operating system, wireless client or installed software (e.g., AppLock) settings.
When the Parameter Scanning parameter is disabled, the scan engine can still scan the Set All Defaults bar code. Default value
of Parameter Scanning is Enable.
When parameters are changed, the new value replaces the standard default value in memory.
See Pre-Configured Defaults (page 5-1) for an alphabetical listing of all default values.
See Also: Reset (page 2-10)
Intercharacter Gap Size (page 5-80) Normal
Macro PDF Not Supported
Macro PDF Transmit/Decode Mode Symbols Not Supported
Transmit Macro PDF Control Header Not Supported
Escape Characters Not Supported
Flush Macro PDF Buffer Not Supported
Abort Macro PDF Entry Not Supported
Redundancy Level (page 5-77) Level 1
Security Level (page 5-79) Level 1
Intercharacter Gap Size (page 5-80) Normal
Set All Defaults
Cancel
Ring Imager Setting 4400 Default