Filter
Top Products
3 - 3
Pairing Status
Scan the bar code to enable pairing in Slave Mode for the Bluetooth module. Upon a successful scan, the Bluetooth mod-
ule then disconnects from the paired device, deletes any saved or current pairing information and transitions into slave
mode.
When pairing as Master device is successful, the module emits a pattern of a short low beep and a short high beep and the
Blue LED blinks slowly, every 4 seconds.
When pairing as Master device is unsuccessful, the module emits a pattern of short low, short high, short high and short
low beeps and the blue LED blinks fast, every 1 second.
See Also: Role Switching (page 3-8)
Note: The LnkB bar codes on some Bluetooth capable mobile devices are quite small. If you are unsuccessful using the
ring imager when scanning a LnkB bar code, change the ring imager’s default Smart Focus Mode to Near Focus by
scanning the Enable Near Focus bar code. Ensure focus mode is changed back to the default value of Smart Focus
after the LnkB bar code read is successful.
* Enable Slave Mode
Enable/Pair as Master
SAMPLE LnkB BAR CODE – DO NOT SCAN. Scan the LnkB bar code on the
Bluetooth capable mobile device (e.g., Thor VM2) and the Bluetooth module is set
to Master Mode. Slave mode is disabled.
Note: Contact Customer Support (page 10-1) if the LnkB bar code is missing from
the Bluetooth capable mobile device. Refer to the device specific user’s
guide (e.g., Thor VM2) for LnkB bar code instruction.