Honeywell 8650 Building Set User Manual


 
8 - 3
Charging Batteries
New batteries should be charged fully before first use. The life and capacity of a Lithium Ion battery pack can vary significantly
depending on the discharge current and the environment in which it is used.
When a battery is placed in a charging pocket, the battery charger begins charging the battery. There is a slight delay while the
charger evaluates the condition of the battery (ambient temperature, remaining charge, etc.) before charging begins.
As with all batteries, expect to see a reduction in the total number of operations a fully charged battery pack can deliver as it
ages. When the battery reaches end of life (end-of-life occurs after 500 charge/discharge cycles) it must be replaced.
Battery packs do not need to be fully discharged between charge cycles.
While charging, the charger and battery pack will generate enough heat to feel warm. This is normal and does not indicate a
problem.
Eight Bay Battery Charger
Front View
Place the charger on a horizontal, hard surface or fasten securely to a wall using the mounting holes. Mounting hardware
is not supplied by Honeywell.
Plug the 2 prong end of the power cord into a properly grounded AC outlet. The power cord is included for US models.
Power cord is sold separately for other models.
Locate or orient the AC cord so that it will not be stepped on, tripped over or subjected to damage or stress.
1. Power Cable Con-
nection location
2. Battery Charging
Pocket
3. LED Indicator
4. LED Function
Legend