Filter
Top Products
4 - 23
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and prepares
the receiving device for the next character in the serial data stream.
The number of stop bits selected (one or two) depends on the number the receiving computer is programmed to
accommodate. Set the number of stop bits to match host device requirements.
Set this parameter by scanning one of the following bar codes.
The SSI Options bar codes are directed toward the host programmer when writing host/scanner interface programs for
different hosts. Contact Customer Support (page 10-1) for technical help.
Time-out Between Decodes, Same Symbol
Default: 1.0 second
Use this parameter to prevent the beeper from continuously beeping when a symbol is left in the scanner's field of view.
To begin setting differing symbol timeout values, scan this bar code:
Using the Keypad Number Symbols (page 4-72) section at the end of this chapter, scan two numeric bar codes that repre-
sent the desired interval, in 0.1 second increments. Valid values are between 0.0 and 9.9 seconds. Single digit values
must be predefined by a leading zero. For example, to set a timeout of 0.5 seconds, scan the Timeout/Decodes – Same
bar code, then scan the number 0 and 5 bar codes.
If you wish to change your number selection, scan Cancel on the Keypad Number Symbols page.
* One Stop Bit
Two Stop Bi ts