Filter
Top Products
2 - 2
Initial Setup
Following are the steps you might take when setting up a new Bluetooth Ring Scanner. More instruction for each step is listed
later in this guide. Contact Customer Support (page 10-1) if you need additional help.
Accessory installation or removal should be performed on a clean, well-lit surface. When necessary, protect the work surface,
the Bluetooth Ring Scanner, and components from electrostatic discharge.
Note: The battery and ring device cables should not be exchanged or replaced in a dirty, harsh or hazardous environment.
When the ring tethers are disconnected, any dust or moisture that adheres to the tether connector can potentially cause
damage upon cable re-connection with the Bluetooth Module.
Hardware Setup
1. Determine which hand or wrist will contain the assembly.
1. Insert the Bluetooth Ring Scanner Module into the leather sleeve.
1. Thread ring cable connector through elastic loop on the appropriate side.
1. Connect the ring cable connector to the Bluetooth Ring Scanner Module.
1. Secure the module strap to the hand or wrist.
1. Connect the ring cable connector to the Module in the sleeve.
2. Insert a fully charged battery in the Bluetooth Ring Scanner Module and the Module powers up.
Software Setup
Set up the Module using an attached ring device and scan the following bar codes in Bluetooth Module Programming Bar
Codes (page 3-1):
• Enable / disable suspend timeout length
• Set the Beeper volume (Bluetooth module only, the rings do not emit sounds)
• Assign a Friendly Name
The Bluetooth Ring Scanner Module is ready to connect to a Bluetooth enabled host device.