Filter
Top Products
6 - 2
12. The upgrade process proceeds and ends with a Successful Upgrade message (see below). The Bluetooth module may
emit a series of beeps or the blue LED may stop flashing and remain illuminated until the upgrade is finished.
13. Click Finish.
14. Remove the battery pack from the Bluetooth Module again.
15. Remove the firmware update cable from the I/O port.
16. At this point, the computer is ready to upgrade the next Bluetooth module, if desired.
Firmware Update Help
If the firmware update is interrupted due to loss of power or by removing the cable before the update is complete, the original
firmware will be destroyed and the Bluetooth Ring Scanner will not be able to run in normal operation mode. If this event occurs
the utility on the host computer indicates that the firmware upgrade was not successful.
This condition can be recovered by repeating the firmware update procedure.
Install BlueCore Device Update Wizard and Driver
Prerequisites:
• BlueCore Device Firmware Update program. Contact Customer Support (page 10-1) to obtain the BlueCore Device Firmware
Update file.
• A desktop/laptop Windows XP (or later) PC with an available USB port.
• A Bluetooth module and a fully charged battery.
• Bluetooth Module Firmware update cable (8650A051CBLBTUPDATE).