Filter
Top Products
5 - 23
Scan Data Transmission Format
Note: Parameter Prefix/Suffix Values for SSI hosts should be set after setting this parameter.
Note: Ring decoder engine prefix and suffix parameters should not be set, changed, or reset using the Prefix and Suffix bar
codes shown in this section. When the Bluetooth Ring Scanner Module is reset to defaults, the prefix and suffix
settings revert to their default values and need to be scanned again. Use the ScanWedge / ScanWedge NGW Power
Tool (Dolphin 70e) or Data Collection / Scanner control panel (all others) in the host computer to store prefix and suffix
values.
Note: Use this option when you want to append a prefix and suffix to the SSI host decode data. If you wish to change your
selection, scan the Cancel bar code and scan again.
Set the Scan Data Transmission Format parameter by scanning one of the following bar codes:
* Data As Is
[Data] [Suffix 1]
[Data] [Suffix 2]
[Data] [Suffix 1] [Suffix 2]
[Prefix] [Data]