Filter
Top Products
38 CHAPTER 2: CONFIGURING THE VCX DATA SERVER
Enabling VCX Data
Server Packet
Tracing
Server packet tracing is enabled by default.
Enable packet tracing for VCX data server using EMS:
1 From the Explorer tab, select the VCX data server.
2 From the Properties tab, select the BES Common Configuration tab.
3 Double-click the PacketTracing field and select enable from the
drop-down list.
4 Click Save all.
VCX Data Server
Configuration Tab
Descriptions
Enterprise Management Suite (EMS) contains several common
configuration tabs. Most of these configurables must be set to their
initial, default configuration.
Tab Location These tabs are available for the VCX data server.
To access these tabs:
1 From the EMS GUI, navigate to the 3Com VCX IP Telephony Server within
the Equipment folder.
2 Click 3COM VCX Data Server.
3 From the left-hand of the GUI, select the Properties tab (default).
3 Q Protocol
Configuration
Use the 3 Q Protocol Configuration tab to enable the proprietary 3Q
protocol for the VCX data server.
Table 9 3 Q Protocol Configuration Tab
Attribute Description Settings
3QenablesStatus Whether or not 3Q Protocol is enabled. Read-only
ClientThread Number of threads to receive data Integer
Range: 1- 4
ControlIPAddress IP address of the Linux workstation
receiving Control Messages.
Read-only
ControlPort Control port number. Default = 1784. Read-only
DataIPaddress IP address of the Linux workstation
receiving data.
Read-only
DataPort Data port number. Default = 1789 Read-only