Filter
Top Products
CHK
ADJ
3 - 44
EBS00121
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
NOTICE
To avoid a short circuit, always set the main
switch to “OFF” when checking or replac-
ing a fuse.
1. Remove:
• seat
Refer to “SEAT, FENDERS AND FUEL
TANK”.
2. Check:
• fuse
a. Connect the pocket tester to the fuse and
check the continuity.
TIP
Set the pocket tester selector to “Ω × 1”.
b. If the pocket tester indicates “•”, replace the
fuse.
3. Replace:
• blown fuse
a. Set the main switch to “OFF”.
b. Install a new fuse of the correct amperage.
c. Set on the switches to verify if the electrical
circuit is operational.
d. If the fuse immediately blows again, check
the electrical circuit.
Pocket tester
90890-03112
Analog pocket tester
YU-03112-C
CHECKING THE FUSES