Filter
Top Products
CHAS
6 - 21
EBS00418
INSTALLING THE REAR BRAKE MASTER
CYLINDER
1. Install:
• brake master cylinder
TIP
• The “UP” mark on the brake master cylinder
bracket should face up.
• Install the brake master cylinder so that the
gaps between the brake master cylinder and
the brake master cylinder bracket are equal.
2. Install:
• copper washers
• brake hose
• union bolt
TIP
• Tighten the union bolt while holding the brake
hose as shown.
• Turn the handlebar to the left and to the right
to check that the brake hose does not touch
other parts (throttle cable, wire harness,
leads, etc.). Correct if necessary.
WARNING
Proper brake hose routing is essential to
insure safe machine operation. Refer to
“CABLE ROUTING” in chapter 2.
Brake master cylinder holder bolt
14 Nm (1.4 m•kg, 10.1 ft•lb)
Union bolt
28 Nm (2.8 m•kg, 20.3 ft•lb)
REAR BRAKE