Filter
Top Products
3 - 23
ADJUSTING THE PARKING BRAKE
CHK
ADJ
ADJUSTING THE PARKING BRAKE
1. Check:
• parking brake cable end length
Out of specification → Adjust.
Parking brake cable end length
2. Adjust:
• parking brake cable end length
a. Loosen the locknut and adjusting bolt .
b. Loosen the locknut .
c. Turn the adjusting nut in direction or
until the specified brake cable end
length is obtained.
d. Tighten the locknut.
e. Slowly turn the adjusting bolt clockwise until
resistance is felt.
f. Turn it 1/8 counterclockwise.
g. Tighten the locknut .
WARNING
After this adjustment is performed, lift the
rear wheels off the ground by placing a
block under the engine, and spin the rear
wheels to ensure there is no brake drag. If
any brake drag is noticed perform the
above steps again.
16 Nm (1.6 m•kg, 11 ft•lb)
53.0 ~ 57.0 mm (2.09 ~ 2.24 in)