Filter
Top Products
6 - 39
CHAS
EBS00465
INSTALLING THE TIE-RODS
The following procedure applies to both of the
tie-rods.
1. Install:
• tie-rod
TIP
• The tie-rod side which must be installed on
the outside has grooves .
• When installing the tie-rod, hold each tie-rod
ball joint with a 14-mm wrench and then
tighten the tie-rod end nut.
2. Adjust:
• toe-in
Refer to “ADJUSTING THE TOE-IN” in
chapter 3.
T
R
.
.
35 Nm (3.5 m · kg, 25.3 ft · lb)
STEERING SYSTEM