Filter
Top Products
3 - 27
CHK
ADJ
CHANGING THE FINAL TRANSMISSION OIL/
ADJUSTING THE DRIVE CHAIN SLACK
EBS00102
CHANGING THE FINAL TRANSMISSION OIL
1. Place the machine on a level surface.
2. Place a receptacle under the final transmission
case.
3. Remove:
• dipstick
• final transmission oil drain plug
4. Drain:
• final transmission oil
5. Install:
• final transmission oil drain plug
TIP
_
Check the gasket (drain plug). If it is damaged,
replace it with a new one.
T
R
.
.
15 Nm (1.5 m·kg, 10.8 ft·lb)
6. Fill:
• final transmission case
NOTICE
NOTICE
_
Take care not to allow foreign material to
enter the final gear case.
7. Install:
• dipstick
Total amount
0.30 L (0.27 Imp qt, 0.32 US qt)
Recommended oil
SAE80 API “GL-4” Hypoid gear
oil
ADJUSTING THE DRIVE CHAIN SLACK
TIP
• Measure the drive chain slack halfway
between the drive axle and the rear axle.
• When checking and adjusting the drive chain
slack, there should be no weight on the vehi-
cle and all tires must be touching the ground.
A drive chain that is too tight will overload
the engine and other vital parts, and one
that is too loose can skip and damage the
swingarm or cause an accident. Therefore,
keep the drive chain slack within the speci-
fied limits.