Filter
Top Products
7 - 8
– +
ELEC
IGNITION SYSTEM
EBS01040
YES
NO
EBS01099
YES
NO
EBS01047
YES
NO
7. Pickup coil resistance
• Disconnect the C.D.I. magneto coupler
from the wire harness.
• Connect the pocket tester ( 100) to the
pickup coil terminal as shown.
Positive tester probe
white/black terminal
Negative tester probe
white/red terminal
• Measure the pickup coil resistance.
Pickup coil resistance
94 ~ 140 at 20 °C (68 °F)
(between white/red and white/
blue)
• Is the pickup coil OK?
Replace the pickup
coil/stator assembly.
8. Source coil resistance
• Disconnect the C.D.I. magneto coupler
from the wire harness.
• Connect the pocket tester ( 100) to the
source coil terminal.
Positive tester probe
black/green terminal
Negative tester probe
black/red terminal
• Measure the source coil resistance.
Source coil resistance
640 ~ 960 at 20 °C (68 °F)
(black/red and green/white)
Replace the pickup
coil/stator assembly.
9. Wiring
• Check the entire ignition system’s wiring.
Refer to “CIRCUIT DIAGRAM”.
• Is the ignition system’s wiring properly
connected and without defects?
Replace the C.D.I.
unit.
Properly connect or
repair the ignition
system’s wiring.
1
1
1
2
2
2
W
W
W /R
B/R B/G
W/B
1
2
W
W
W /R
B/R B/G
W/B
→
→
→
→
Ω ×Ω ×
Ω Ω