Filter
Top Products
24-Pump, 128-Station Controller Chapter 4: Operation 62
3-5 Alarms
Reviewing Alarms
At the Station Status or Pump Status screen:
1. Touch Alarms.
The Alarm Log screen appears, with the newest alarm listed first:
To scroll up and down through the list:
• Touch ▲ and ▼ at the bottom of the list.
Silencing Alarms
Whenever a new alarm occurs, your controller sounds the horn and turns on the strobe light at
each central alarm. If the alarm is for a specific station or pump, and if the station or pump
has a local alarm, the controller also turns on the local alarm light. In addition, a banner
appears on the touch screen displaying an alarm message and a Push To Silence button.
To silence the alarm:
1. Touch Push to Silence on the alarm banner.
The horns and lights at the central alarms turn off. (The local alarm light stays on.)
The banner will close. Your controller has separate, configurable settings for how
long the horns should remain silent and how long the lights should remain off. If the
alarm condition still exists when either of these times elapses, the corresponding
devices (horns or lights) turn on again. If a new alarm occurs, both the horns and the
lights turn on.