Filter
Top Products
24-Pump, 128-Station Controller Chapter 3: Installation 28
Connecting Vacuum Pumps and Filter Chambers to the Network
Connecting Vacuum Pumps
Make sure that all previous installation steps have been done first before starting this task..
To connect a vacuum pump to the network:
1. Attach patchcords from vacuum pump junction boxes to the appropriate ArmorBlock
connectors. See Figures 12, 13, and 14.
Figure 12: 4-Vacuum Pump ArmorBlock Connections
Note 1: The block shown is addressed 33, for the first (2) pumps. The block addressed
34 would have connectors for pumps 3 and 4, etc.
Note 2: If a pump does not have “Pump Fault #2” or a local pump alarm light, the T
connector is not required. Connect the patchcord directly to the connector on the
ArmorBlock.