Filter
Top Products
24-Pump, 128-Station Controller Chapter 3: Installation 25
Figure 9: Proper Power Supply Enclosure Connections
Connecting Vacuum Receivers to the Network
Make sure that all previous installation steps have been done first before starting this task.
To connect a vacuum receiver to the network:
1. Attach patch cord from vacuum hopper junction box (station demand) to appropriate
input connector. See Figures 10 and 11 (connection is shown on first hopper on the block
only for clarity.)
2. Dress the excess patch cord cable with cable ties so it does not interfere with operation
and gives a pleasing appearance.