Sterling 882.00255.00 CV3-655 Musical Table User Manual


 
24-Pump, 128-Station Controller Chapter 3: Installation 44
4. As appropriate, either continue copying to other stations, or touch Station Setup
to go back to the Station n Setup screen.
To copy the selected station’s settings to a range of other stations
1. Touch First Station button next to the green button labeled “Copy to Range
of Stations.”
The keypad pops up.
2. Enter the station number for the hopper at the lower end of the range you are copying
to. Use to erase any mistakes. Use to enter the value.
The keypad disappears and the Station Copy screen shows the station number you
entered under First Station.
3. Touch Last Station button next to the light grey button labeled First
Station.
The keypad pops up.
4. Enter the station number for the hopper at the upper end of the range you are copying
to. Use to erase any mistakes. Use to enter the value.
The keypad disappears and the Station Copy screen shows the station number you
entered under Last Station.
5. Touch the green Copy To Range of Stations button.
Copy Complete” briefly appears at the top of the screen.
6. As appropriate, either continue copying to other stations, or touch Station Setup
to go back to the Station n Setup screen.
To copy the current station’s settings to all other stations
1. Touch the green Copy To All Stations button.
Copy Complete” briefly appears at the top of the screen.
2. Touch Station Setup to go back to the Station n Setup screen.
Setting Up Pumps
Before starting the system, you must define several settings for each pump, such as how
quickly to shut it down when it is not in use and whether the pump has a local alarm. This
section first discusses how to use the controller’s menu system to configure pumps. The table
on page 77 discusses the individual choices.
Setting Up a Single Pump
1. Go to the Pump Status screen.
To reach this screen from any other screen, touch Pumps on the right side of the
screen. The Pump Status screen appears: