Renesas R5S72621 Doll User Manual


  Open as PDF
of 2152
 
Section 13 Watchdog Timer
R01UH0134EJ0400 Rev. 4.00 Page 667 of 2108
Sep 24, 2014
SH7262 Group, SH7264 Group
13.3.3 Watchdog Reset Control/Status Register (WRCSR)
WRCSR is an 8-bit readable/writable register that controls output of the internal reset signal
generated by watchdog timer counter (WTCNT) overflow.
Note: The method for writing to WRCSR differs from that for other registers to prevent
erroneous writes. See section 13.3.4, Notes on Register Access, for details.
76543210
00011111
R/(W) R/W R/W R R R R R
Bit:
Initial value:
R/W:
WOVF RSTE RSTS - - - - -
Bit Bit Name
Initial
Value R/W Description
7 WOVF 0 R/(W) Watchdog Timer Overflow
Indicates that the WTCNT has overflowed in
watchdog timer mode. This bit is not set in interval
timer mode.
0: No overflow
1: WTCNT has overflowed in watchdog timer mode
[Clearing condition]
When 0 is written to WOVF after reading WOVF
6 RSTE 0 R/W Reset Enable
Selects whether to generate a signal to reset the LSI
internally if WTCNT overflows in watchdog timer
mode. In interval timer mode, this setting is ignored.
0: Not reset when WTCNT overflows*
1: Reset when WTCNT overflows
Note: * LSI not reset internally, but WTCNT and
WTCSR reset within this module.
5 RSTS 0 R/W Reset Select
Selects the type of reset when the WTCNT overflows
in watchdog timer mode. In interval timer mode, this
setting is ignored.
0: Power-on reset
1: Manual reset
4 to 0
All 1 R Reserved
These bits are always read as 1. The write value
should always be 1.