Renesas R5S72621 Doll User Manual


  Open as PDF
of 2152
 
Section 34 User Debugging Interface
Page 1820 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
34.2 Input/Output Pins
Table 34.1 Pin Configuration
Pin Name Symbol I/O Function
Serial data input/output
clock pin
TCK Input Data is serially supplied to this module from the
data input pin (TDI), and output from the data
output pin (TDO), in synchronization with this clock.
Mode select input pin TMS Input The state of the TAP control circuit is determined
by changing this signal in synchronization with
TCK. The protocol complies with the JTAG
standard (IEEE Std.1149.1).
Reset input pin TRST Input Input is accepted asynchronously with respect to
TCK, and when low, this module is reset. TRST
must be low for a period when power is turned on
regardless of using the function. See section
34.4.2, Reset Configuration, for more information.
Serial data input pin TDI Input Data is transferred to this module by changing this
signal in synchronization with TCK.
Serial data output pin TDO Output Data is read from this module by reading this pin in
synchronization with TCK. The initial value of the
data output timing is the TCK falling edge, but this
initial value can be changed to the TCK rising edge
by inputting the TDO transition timing switching
command to SDIR. See section 34.4.3, TDO
Output Timing, for more information.
ASE mode select pin ASEMD* Input If a low level is input at the ASEMD pin while the
RES pin is asserted, ASE mode is entered; if a high
level is input, product chip mode is entered. In ASE
mode, dedicated emulator function can be used.
The input level at the ASEMD pin should be held
for at least one cycle after RES negation.
Note: * When the emulator is not in use, fix this pin to the high level.