Filter
Top Products
2. INSTALLATION
2-6
2.3 Installation Method
1) Remove the front covers. (Upper and lower)
2) Remove the wiring cover.
3) Pass screws or bolts into the four mounting holes and secure the drive unit.
(Three mounting holes for 0.75K or less)
CAUTION
Prevent screws, metal pieces and other conductive foreign matter and
oil and other flammable foreign matter from entering the drive unit.
Securely screw or bolt the unit to the mounting surface vertically
without looseness. Always install the unit in the specified mounting
orientation. Not doing so can cause a failure.
Do not drop the unit, or subject it to impact.
4) Replace the removed cover. Leave the cover removed when continuing the
wiring work.
NOTICE
Fully check that the front cover has been mounted securely.
Insecure mounting can cause a drop due to vibration.
The front cover (Lower) is fitted with the capacity plate and the drive
unit with the name plate. The same serial number is printed on
these plates. Always reinstall the cover to the drive unit from where
it had been removed.