Mitsubishi Electronics MD-CX522-04K to s.7K Building Set User Manual


 
2. INSTALLATION
2-3
2
2.2 Preparation of Peripheral Devices
2.2.1 Basic configuration
I/O
M
UVW
RST
P/+
P1
PR
N/-
U
V
W
Always connect either of the above for
circuit (wiring) protection. Make selection
in accordance with the selection table.
Choose the earth leakage circuit breaker
which has harmonic suppression.
No-fuse breaker or earth leakage
circuit breaker
Refer to: 2.2.2 Selection of peripheral
devices
Reactor (FR-BAL)
Install it for power factor improvement,
power coordination, or harmonic
suppression.
Radio noise filter (FR-BIF)
Connect it to reduce radio noise
in the AM frequency band.
This filter is designed for use on
the input side only.
Parameter unit
(FR-PU04)
Analog signal
setting potentiometer
Contact signal
switch
Meter
Low-voltage manual switch
Connect it in any application where the
motor is run by the load after the drive unit
has been powered off.
Refer to: Page 3, 1. Usage
Motor
Power equipment capacity
As the power equipment capacity,
select the kVA value not less than
the one given in the specifications.
Refer to: Chapter 7, 7.1.1
Rating specifications
PU
connector
Magnetic contactor
Make selection in accordance
with the selection table.
Refer to: 2.2.2 Selection of
peripheral devices
Line noise filter
(FR-BSF01) (FR-BLF)
Connect it to reduce high
frequency noises outgoing to the
power supply side.
Its effect is higher as the number
of wire turns is greater.
Main circuit cables
Choose the wire size in
accordance with the selection
table.
Refer to: 2.2.2 Selection of
peripheral devices
Reactor (FR-BEL)
Install it for power factor
improvement, power
coordination, or harmonic
suppression.
Brake resistor (MRS)
(FR-ABR)
Connect it to increase braking
capability for deceleration.
Line noise filter
(FR-BSF01) (FR-BLF)
Connect it to reduce high
frequency noises outgoing to
the output side.
When installing it on the output
side, do not turn the wire more
than four times.
Magnetic motor
Use the specified motor.
It cannot be run using
commercial power.
BU brake unit, Discharge
resistor
Connect it to increase braking
capability for deceleration.