Filter
Top Products
Section 17 I
2
C Bus Interface 3
Page 890 of 2108 R01UH0134EJ0400 Rev. 4.00
Sep 24, 2014
SH7262 Group, SH7264 Group
17.7 Usage Notes
17.7.1 Note on Setting for Multi-Master Operation
In multi-master operation, when the transfer rate setting for this module (ICCR1.CKS[3:0]) makes
this LSI slower than the other masters, pulse cycles with an unexpected length will infrequently be
output on SCL.
Be sure to specify a transfer rate that is at least 1/1.8 of the fastest transfer rate among the other
masters.
17.7.2 Note on Master Receive Mode
Reading ICDRR around the falling edge of the 8th clock might fail to fetch the receive data.
In addition, when RCVD is set to 1 around the falling edge of the 8th clock and the receive buffer
full, a stop condition may not be issued.
Use either 1 or 2 below as a measure against the situations above.
1. In master receive mode, read ICDRR before the rising edge of the 8th clock.
2. In master receive mode, set the RCVD bit to 1 so that transfer proceeds in byte units.
17.7.3 Note on Setting ACKBT in Master Receive Mode
In master receive mode operation, set ACKBT before the falling edge of the 8th SCL cycle of the
last data being continuously transferred. Not doing so can lead to an overrun for the slave
transmission device.