Filter
Top Products
7 - 16 7 - 16
MELSOFT
7. SYSTEM CHECKING FROM PERIPHERAL DEVICE
HELPFUL CORRECTIVE ACTIONS
Take the following corrective actions when the speed check cannot be made.
Status Corrective Action
Check that the servo amplifier is powered.
Servo signal is OFF
Check the connection of the external I/O signal connector.
Check that the servo amplifier is powered.
Ready signal is OFF
Check the connection of the external I/O signal connector.
Alarm signal is ON Take the corrective action given in the servo amplifier installation guide.
Check the connection of the external I/O signal connector.
Upper/lower limit is OFF
Check for any object in contact with the upper/lower limit switch.
Stop signal is ON Turn off the external stop signal.
JOG operation cannot be
performed.
Check that JOG speed setting is not "0".
Error/warning occurred
Check the error/warning code using [Help] (refer to Section 12.11), and check and remove
the cause.