Filter
Top Products
3 - 18
CHK
ADJ
ADJUSTING THE STARTER CABLE
2.Adjust:
*****************************************************
Adjustment steps:
●
Disconnect the starter cable 1 from the
carburetor body.
N
OTE:
Do not remove the starter plunger 2 from the
starter cable.
●
Measure the starter plunger stroke distance
a of the starter lever 3 fully close to fully
open position. If the distance is out of
specification adjust it as described below.
È
Fully closed position
É
Fully open position
●
Pull back the boot 4.
●
Loosen the locknut 5.
●
Turn the adjuster 6 in or out until the correct
free play is obtained.
●
Tighten the locknut 5.
●
Push in the boot 4.
●
Connect the starter cable to the carburetor.
WARNING
After adjusting the cable, turn the
handlebar to right and left, and make sure
that the engine idling speed does not
increase.
*****************************************************
Starter plunger stroke distance:
15 mm (0.59 in)
Turning in Free play increased.
Turning out Free play decreased.
3.Install:
●
Fuel tank side panel (left)
●
Seat
Refer to “SEAT, CARRIERS, FENDERS
AND FUEL TANK”.