Filter
Top Products
7 - 21
DRIV
REAR AXLE/FINAL DRIVE GEAR AND DRIVE SHAFT
Shims are supplied in the following
thicknesses.
*****************************************************
Final drive pinion gear shim
Thickness (mm)
0.15 0.30 0.40
0.45 0.50 0.60
Ring gear shim selection
1.Select:
●
Ring gear shim(s)
*****************************************************
Selection steps:
●
To find the ring gear shim thickness “B”, use
the following formula.
c = a numeral (usually a decimal number)
on the final gear case either added to or
subtracted from 45
d = a numeral (usually a decimal number)
on the outside of the ring gear bearing
housing and added to 1
e = a numeral (usually a decimal number)
on the inside of the ring gear either
added to or subtracted from 35.00
f = bearing thickness (considered constant)
Example:
1) If “53” is stamped on the final gear case,
c = 45 + 0.53 = 45.53
2) If “05” is stamped on the ring gear
bearing housing,
d = 1 + 0.05
= 1.05
3) If “– 05” is stamped on the ring gear,
e = 35 – 0.05
= 34.95
4) f = 11.00.
Ring gear shim thickness:
“B” =
c
+
d
– (
e
+
f
)
Bearing thickness
f
:
11.00 mm